Jefftron Micro Mosfet II with Active Brake for AEG Rifle

Professionally made mosfet designed for airsoft electric guns (AEG). With Active Brake
Device increases gun rate of fire and battery holds longer, than with basic wiring.

SPECIFICATIONS:
- Very small device dimension, it fits nearly everywhere
- Devices without wires, you can use max. 1,5qmm (AWG16) power wires and 0,25qmm (AWG21) signal wires
- suitable for service center, if you are not familiar with soldering to the circuit board, choose device with wiring and accessories.
- Designed for spring up to M160 (equivalent for current 25A for duration 10s). For higher load please use Extreme mosfet
- Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- Active Brake for right Cyklus
- 5 wires connection
- positive wire isn't connect into device
- device size 15x7x5mm
- No current consumption in the idle mode
- No sparking on switch contacts
- In auto fire mode piston stops in random position due the mechabox design
- For right function is necessary to have a functional gearbox cut off lever, selector plate, reverse latch, trigger and trigger block, as it has the standard gearbox
- special for change Cyma Gen3 Mosfet

DEVICE INSTRUCTIONS: you can download installation manual in English here [PDF, 673.34 kB]
PACKING: device, heat shrink tube and installation manual in English

WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!