The CM041L is a new model.. The body is made of metal, as is the outer barrel and the mounts of the PDW shaft. The shaft itself, the pistol grip and the front grip are made of polymer. The M-Lok handguard and the fake cocking lever are made of CNC. T The new 110-round polymer mag with visible fake cartridges completes the aggressive look. The barrel has a 14mm CCW thread:
With Eshooter ETU Gen2.
Eshooter MOSFET
The replica is equipped with an
advanced programmable Eshooter ETU (Electronic Trigger Unit), which offers:
- additional fire modes (BURST, BINARY)
- pre-cocking adjustment
- protection of the mechanism and battery
Main features:
- Easy programming in 3 steps. Reset possible by holding the trigger for 8 seconds.
- 5 levels of piston pre-cocking adjustment.
- Compatibility with brushless motors as well as High Speed / High Torque motors.
- Active Brake - stabilization of gear operation.
- Motor lock protection.
- Protection against over-discharge and low/high voltage (2S minimum 6V, 3S minimum 8.5V, maximum 17V).
Caliber: 6mm
Drive: AEG
Gearbox: V2 with Mosfet processor unit
Engine: High Speed Gen.3
Hop up: adjustable
Fire Mode: Save,Semi,Fullauto
Inner barrel: 290mm
Weight: 2700g
Length: 556mm
Connection: T-plug Dean plug
Recommended: 7.4V Li-PO
.webp "Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
.webp "Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
.webp "Preview: Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
.webp "Preview: Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
.JPG "Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
.JPG "Cyma CM041L PDW Eshooter ETU Gen2. Black 0,5 Joule AEG")
